PDA

View Full Version : 97 S10 reg cab (NEW)



bones22
01-25-2008, 08:33 PM
10" Audioque HD3 off of a Cadence ZRS10

had to start a new thread to show the new box since the other was trashed. i managed to get some extra air space by changing the design.

everything will be going into the truck tomorrow. i will take more pics after the box is covered. ill also try to get some vids.


2.059 cu ft
tuned to 40.5hz



http://i32.tinypic.com/24fl6iu.jpg

http://i29.tinypic.com/257g1oh.jpg

http://i30.tinypic.com/2m3frqv.jpg

http://i27.tinypic.com/25foxeo.jpg

Louisiana_CRX
01-25-2008, 08:34 PM
Looks nice....

etznova
01-25-2008, 08:36 PM
nice build, but it doesn't look like enough port area

bones22
01-25-2008, 08:37 PM
da*n its cold

bones22
01-25-2008, 08:39 PM
nice build, but it doesn't look like enough port area

i thought the exact same thing but every program i used gave the same measurements

etznova
01-25-2008, 08:43 PM
its for a 10" right how big is the port and box vol.

bones22
01-26-2008, 09:41 PM
completed pics will be up in the morning the paint is drying still.

in my opinion it looks pretty da*n good.

Blove1991
01-27-2008, 04:16 PM
Make sure you get vids

bones22
01-27-2008, 06:20 PM
it was getting to dark for vids today i will try tomorrow when i get home from work.

all i can say is LOUD and excursion is nuts

i have some serious fine tuning to do so my amp doesnt destroy the sub.


http://i28.tinypic.com/1587fya.jpg

http://i29.tinypic.com/28vcfmg.jpg

http://i31.tinypic.com/wc1m9y.jpg

http://i32.tinypic.com/34i5mq8.jpg

http://i32.tinypic.com/zohr2h.jpg

Kold_Killa
01-27-2008, 10:15 PM
Pretty **** nice for a reg cab!!!

MTXman
01-27-2008, 10:23 PM
Looks good man.

bones22
01-27-2008, 10:25 PM
thanks guys. there is already 1 thing i have to do.

replace the rear slider way to much rattling from it. its a da*n shame to i just had the window put in. oh well.

Crodski
01-27-2008, 10:26 PM
what is the measurement on the bottom and top pieces? i want to maximize available space in my truck as well

Calikid
01-27-2008, 10:28 PM
sweet


gN

bones22
01-27-2008, 10:33 PM
what is the measurement on the bottom and top pieces? i want to maximize available space in my truck as well

i did it in 2 pieces since the back wall isnt totaly straight but the height to the edge of the widow is 23 1/4 with all the plastic out of the way. if you dont mind cutting the plastic on the sides you could manage to get about 58 inches rather than the 50 from the plastic to plastic. so you could pick up a good amount of airspace.