PDA

View Full Version : Chevy S10 ex. cab ported box for Fi



01 S 10
01-08-2008, 12:52 PM
Im in need of some help on building my first ported box, ive built sealed before, but im still a NOOB. Im using the RE calculator: http://www.reaudio.com/speaker_box/LPort_Box_Calc.html
and if someone can punch these following numbers in this order from top to bottom as follows:
*47.5
*26
*10
*20
*0.75
*4
*6

This is going to be for 2 15" Fi SSD's powered off my Sundown 1500SAZ. The SSD's are requiring 3-4 cubes each, im wondering if this enclosure will be appropriate for my setup.

T.I.A. !

Cody

01 S 10
01-08-2008, 02:49 PM
??? bump

Flipx99
01-08-2008, 02:51 PM
You are building right to the edge, eh? I wouldn't go wider than 46, but that is me. If you look at how the jump seat works, the depth changes as you move in from the back wall.

01 S 10
01-08-2008, 02:56 PM
jump seat will be cut OUT! lol, no need for it, ill save the actual seat and buy a new panel if i get rid of the truck or something. But im going to cut that panel so it doesnt stick out. the box could be closer to 51" - 52", but im leaving room to mount the sundown on the drivers side. so the actual box will be about 47"- 48".

Flipx99
01-08-2008, 03:01 PM
Gotcha...

I would PM IonSql. He does all my designs. He charges $10, but you will get something really ncie.

01 S 10
01-08-2008, 03:03 PM
ok, sounds good. I'll do that when im absolutely 100% sure im getting the SSD's (im about 99.9% positive right now:D).

thanks again Flipx99