PDA

View Full Version : port question



ws140
04-03-2003, 08:37 PM
what is the difference between a square vent where you just cut out a part of a side vs a pipe sort of port?

Frraksurred
04-04-2003, 01:47 PM
They are one of two box designs, either they are both ported and the one with the square hole is using an internal "tunnel" as it's port, or it's a bass reflex box which is a whole different story.

Both box types take specific planning and design to work with the specific sub(s) you put in them, so don't think if you cut a hole in your box you'll have a ported enclosure. Not that you're planning on doing that, but I've seen it happen. :)

Here's a good article (http://www.termpro.com/articles/buildbox.html) to read, it will give you a good foundation on enclosure types.

God bless!