PDA

View Full Version : Box Dimensions



BuckyBoy
11-25-2007, 04:48 PM
I have an Eclipse SW7200 12" Sub and this is what it calls for in the manual...

2.0 CuFt Ported (Vented) Enclosure F3=32Hz Fb=34Hz Port=3x6" PVC

Could someone give me a box design using that. I want the maximum height to be 10-12 inches. I would really appreciate it. If you use one of those programs that shows me the box inside and out and the dimensions and everything, then I will send you a couple bucks through paypal. Thanks

rcnshoe
11-25-2007, 05:11 PM
Gimme a PM. I need L + W + H of box. What do you want tuned at? Lemme know. Also what kind of car its going in.

BuckyBoy
11-25-2007, 05:19 PM
Gimme a PM. I need L + W + H of box. What do you want tuned at? Lemme know. Also what kind of car its going in.
Sent.

BuckyBoy
11-25-2007, 08:21 PM
I did one myself with sketchup
http://i233.photobucket.com/albums/ee141/smithgt/Box.jpg
It is 2.4 CuFt and to tune it to 32Hz I need a port of 2.5x3.5 or 3x5.5 or 3.5x8 or 4x10.75. Where do I put the port? I want it facing up. Do I just put one on the side on the top of the box that is say 3 inches wide and 5.5 inches long?

BuckyBoy
11-25-2007, 08:45 PM
Is this how the port should be?
http://i233.photobucket.com/albums/ee141/smithgt/Box2.jpg

rcnshoe
11-26-2007, 06:54 AM
:smokin: http://i13.photobucket.com/albums/a284/kinscsi/2000MitsubishiEclipse.jpg

Ok box designed lemme know if you like it. Took about less then 2 hours. I was bored =p. I have the *.SKP file to send you if you want it. Just need an e-mail where it can be sent.