PDA

View Full Version : Cuting Angles



bopo668
10-19-2007, 10:16 AM
I was wondering how you guys go about this.what tool do you use to cut the angle where joints meet like down the sides example http://s31.photobucket.com/albums/c393/bopo668/?action=view&current=Angle.jpg

kbkid
10-19-2007, 10:24 AM
I doubt I'm the only one, but I can't see the picture. Its too small.

ufvj2172
10-19-2007, 10:26 AM
you can use a table saw, a skil saw (just adjust the little thing to whatever degree angle you need)

etc

kbkid
10-19-2007, 10:40 AM
You can actually tell what the picture is referring to or are you just posting?

tuck05
10-19-2007, 10:53 AM
Table saw.

ufvj2172
10-19-2007, 11:05 AM
You can actually tell what the picture is referring to or are you just posting?

hes asking for an angle, so im telling how to cut an angle, lol

ramos
10-19-2007, 11:44 AM
From the tiny picture it doesn't look like a mitered cut . Just looks like a straight cut to me :)

helotaxi
10-20-2007, 11:35 AM
The parallax of the picture makes it difficult to tell I'm pretty sure that it is a mitered cut on just the one panel (sloped side of a hatchback style box). I use the same tool I use for every other cut: table saw.

kbkid
10-20-2007, 11:35 AM
ramos, thats what I'm saying.

bjfish11
10-21-2007, 11:30 AM
It looks slightly slanted to me. I can see it by looking at the actual red outline of the edge of the panel. Easiest way to cut angles is on the table saw.