PDA

View Full Version : whatcha think? w/ picture UPDATED



sinosic
09-27-2007, 12:32 PM
i changed my design arround a bit.
http://www.caraudio.com/forum/showthread.php?t=260721
it looks like a normal slot ported enclosure, but i think the flare on the inside of the port with the two angle pieces make it very efficent. i think im going to try it out if i get some spare time today
http://img232.imageshack.us/img232/8480/2bprotogz3.jpg (http://imageshack.us)
http://img74.imageshack.us/img74/4269/2protoly8.jpg (http://imageshack.us)
http://img74.imageshack.us/img74/6369/2cprotoww0.jpg (http://imageshack.us)

spoonraker
09-27-2007, 06:04 PM
I don't see the point in the huge corner pieces?

(going by the top picture)

The top corner piece is ridiculously huge. Is it part of the port or what? If it's just a 45 corner that big than it's doing nothing other than taking up airspace, you could make it 1/3 that size and get just as much benefit from doing it.

The bottom corner is what confuses me. I see three different widths : The inside angled piece to the back wall, the inside angled piece to the corner piece, and the main port width. These should all be exactly equal. Just from eyeballing the sketch-up they look to be off. If the entire length of the port isn't the same width it will throw off your tuning. Post some measurements.

mobeious
09-27-2007, 07:23 PM
that encloser looks like alot of unused space, there is easier ways of making a more efficent box that is smaller

sinosic
09-27-2007, 07:56 PM
its funny how someone can post the same thread in two different forums and get totally different replies.

http://www.stevemeadedesigns.com/board/index.php?showtopic=10653&st=0&p=167994&#entry167994

:rolleyes: