PDA

View Full Version : ZX650.4 powering 2comps & 2 coax



rmdl51
09-15-2007, 02:14 PM
Hello, I'm using a Kicker zx650.4 to power up 2 6.5 phoenix gold RSD and on the rear I have 2 Pionner coaxials which are 80W rms, I know the PG are power hungry but what about the Coaxials:

The kicker amp will give 120x4 @4ohm so, Is ok to give 120w rms to these Pionners:

http://cgi.ebay.com/PIONEER-6-X-9-5-WAY-SPEAKERS-TS-A6992R-TSA6992S_W0QQitemZ280150294003QQihZ018QQcategoryZ1 4942QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Thanks!

05gliguy
09-15-2007, 02:34 PM
should be alright

kross
09-16-2007, 05:22 AM
Yes, that's fine.

rmdl51
09-17-2007, 04:23 AM
Ok Thanks a lot! I have another question about this amp, it has two 4-pin connectors (+)(-)(-)(+) that say High level inputs, what are this for? the manual doesn't say anything except that if I use the HLI I should use the RCA dummy plugs in order for the fader to work properly. I don't even understand which fader means.

Maybe I shouldn't worry about that and just use the RCA's but I was just interested on learning what are those Inputs for. I will appreciate if someone can give me some info about it, Thanks again.

kross
09-17-2007, 01:27 PM
That's for hooking up to headunits that don't have RCA outputs, i.e. factory systems. You hook into the speaker output from the headunit instead, and feed it into the high level input on the amp.