View Full Version : i have a ?? for u

03-11-2003, 10:35 PM
how do u get the smoth finish on out side of the box with the flow coat . the glass on the box is not extremly rough but it not super smotth . any idea ? any sugestion . would be appreaciated

03-11-2003, 10:39 PM
sorry this is fibre glass i try to coat with fiberglass try to coat with the flow coat

03-12-2003, 01:05 AM
sorry didn't really get wat u asked. but u wanna smooth out the fiberglass or the plexyglass? well if it's for fiberglass, u can prob try to use a sander to smooth it out.

03-12-2003, 05:29 PM
bondo for smoothing

03-13-2003, 09:30 AM
Here are 10 easy steps to get it smooth.

1. sand
2. sand
3. sand
4. sand
5. sand
6. Apply a little body filler to smooth out any pinholes.
7. Sand
8. check for pinholes, dips, rough spots
9. apply more filler to fill anything you found in step number 8
10. Sand some more


03-13-2003, 08:31 PM
If this is for Plexiglass then I think I heard that you could also sand it smooth. The procedure was something like take the highest grit sandpaper you can find like 1000 grit and wet sand the plexi. Then if you want it even smoother then you can take and gradually increase the grit as you sand. Then again a propane or oxy/acteylene torch can smooth it out to allthough with this method you have you be carefull and make sure you dont stay in one spot for too long or it will melt the plexi but eventually it will smooth it out very very nicely. The heat of the flame just barely touching the Plexi surface causes a very this layer on the top of the plexi to melt and run into any imperfections and such. Hope this helps as well;)