SHiZNiLTi
08-30-2007, 11:17 PM
I was bored so I decided to make a video about the box I made a while back that I actually just started using since my project for the (2) RE MT 18's in 16cuft is on hold for a while.
It's 2cuft tuned to 28hz with 30sq.in. of port area.
I made this box using a "snake" port as some say, I loaded up a 10" kicker L7 wired in 2ohm that I had laying around into it and it sound's really sweet. In the past I've tested the kicker in a stander L-Slot port box that was 2.2 cuft @ 32hz and I have to say this "snake" port design thats tuned to 28hz sounds much better, surprisingly there is no port noise either. You can really feel the lows and it flexs the blazer pretty good considering I have a couple trunk kits of dynamat xtreme on the entire roof.
The sub can take alot of power(the amp gain is all the way down) I was pushing it to it to the point just before cone distortion.
Here's the video...
http://i113.photobucket.com/albums/n228/SHiZNiLTi/th_L7KICKER.jpg (http://s113.photobucket.com/albums/n228/SHiZNiLTi/?action=view¤t=L7KICKER.flv)
http://www.youtube.com/watch?v=-q5u-gsykLM <-- alternate link
Here's a few pics of the build...
http://img294.imageshack.us/img294/5171/beforeportgu6.jpg
http://img167.imageshack.us/img167/3184/box3rc3.jpg
http://img167.imageshack.us/img167/9792/box2fx0.jpg
http://img167.imageshack.us/img167/1569/box18gz5.jpg
It's 2cuft tuned to 28hz with 30sq.in. of port area.
I made this box using a "snake" port as some say, I loaded up a 10" kicker L7 wired in 2ohm that I had laying around into it and it sound's really sweet. In the past I've tested the kicker in a stander L-Slot port box that was 2.2 cuft @ 32hz and I have to say this "snake" port design thats tuned to 28hz sounds much better, surprisingly there is no port noise either. You can really feel the lows and it flexs the blazer pretty good considering I have a couple trunk kits of dynamat xtreme on the entire roof.
The sub can take alot of power(the amp gain is all the way down) I was pushing it to it to the point just before cone distortion.
Here's the video...
http://i113.photobucket.com/albums/n228/SHiZNiLTi/th_L7KICKER.jpg (http://s113.photobucket.com/albums/n228/SHiZNiLTi/?action=view¤t=L7KICKER.flv)
http://www.youtube.com/watch?v=-q5u-gsykLM <-- alternate link
Here's a few pics of the build...
http://img294.imageshack.us/img294/5171/beforeportgu6.jpg
http://img167.imageshack.us/img167/3184/box3rc3.jpg
http://img167.imageshack.us/img167/9792/box2fx0.jpg
http://img167.imageshack.us/img167/1569/box18gz5.jpg