First time fiberglass project

[SplChoice-]

:blackeye: It was hard at first but u start getting used to it, mostly just re applying sanding sanding re apply the indents sanding sanding im getting there but i only took a few pics at the start...heres some
first layer of mat not cleaned up:
http://i11.photobucket.com/albums/a176/xxYupxx/IMAGE_076.jpg

http://i11.photobucket.com/albums/a176/xxYupxx/IMAGE_075.jpg

http://i11.photobucket.com/albums/a176/xxYupxx/IMAGE_074.jpg

this is where im at now really more sanding and filling in u can see where im sanding right now just takes time and my fingers are sore its getting there but it will turn out good
http://i11.photobucket.com/albums/a176/xxYupxx/IMAGE_084.jpg

http://i11.photobucket.com/albums/a176/xxYupxx/IMAGE_081.jpg

http://i11.photobucket.com/albums/a176/xxYupxx/IMAGE_080.jpg

more updates soon to come i need a rest

[pitbull12887]

urm.....i hope it turns out right lol, good luck

[SplChoice-]

it will that **** aint going no where i drilled so many holes and fiberglassed the back so its held on from the door panel just sanding takes forever man thats why u havent got a real clean look. its getting there like i said :( not bad for a first timer

[mlstrass]

Are you sanding that by hand? If so spend a few $$$ on an electric sander. Can get them for $20 and it's hella easier that way...

[got_focus?]

looking real good bro......starting mine here shortly....taking a little different approach, but along the same lines as you!

VERY good work for a first time job!

Also, as said above....either get a air sander or electric!

[Tonyguy]

nice work, keep it up.

[SplChoice-]

heres where im at now havent worked on it really that much but needs more sanding for sure and the door is dirty lol but u can get a peep
http://i11.photobucket.com/albums/a176/xxYupxx/Picture303.jpg

http://i11.photobucket.com/albums/a176/xxYupxx/Picture302.jpg

http://i11.photobucket.com/albums/a176/xxYupxx/Picture301.jpg

[CrazedCat]

coming along nicely it seems

[inapontiac]

How can you use the handle to shut the door or are you going to roll the windows down every time?

[troy_audi0]

Are you on www.fiberglassforums.com ??
if not you should be
Nice looking so far
Troy

[SplChoice-]

na in the pic it looks like i went up to the handle look in the first pic u can see through the handle kinda camaflouged but u can see through.... i didnt its flush underneath the handle is still how it was it looks like its connected to it but its not and no im not on fiberglass forums.. im a newb at this lol

[phyphoestilic]

Did u just body filler 1/2 the door? Cause that might crack over time with the door shutting and stuff.

[SplChoice-]

yeah i used fiberglass bondo, it sticks to it well its like a hard hard plastic and i scuffed it up pretty bad so we'll see