PDA

View Full Version : SSC6 Crossover *Quick Help*



scotsman
07-12-2007, 03:27 PM
I noticed that the woofer in my driver door from this comp set wasn't working. I took off the crossover and found this. Is there anyway to fix this or do I need a new crossover? That wound up coil is hanging loose on 1 side, can I just glue it back together, I'm guessing i need to get it to sit in that little hole where it came out of and make a connection.
http://img393.imageshack.us/img393/2697/img0188qq8.jpg
http://img376.imageshack.us/img376/8700/img0189ok4.jpg
http://img376.imageshack.us/img376/1656/img0191vs9.jpg

scotsman
07-12-2007, 03:34 PM
anyone?

scotsman
07-12-2007, 03:42 PM
i want to fix these soon

Latina33
07-12-2007, 03:45 PM
Hey man, not sure how to fix that, or if a fix will work, but I do have 1 used SSCS6 crossover that I could sell you if you end up not being able to fix that one.

Just throwing it out there for you, just in case.

scotsman
07-12-2007, 03:47 PM
I saw that, I'll def pick it up if I cant fix this.

scotsman
07-12-2007, 03:59 PM
doors want to go back on, someone help me

headless
07-12-2007, 04:08 PM
You could try soldering it back down...should work if re-soldered, i would imagine.

scotsman
07-12-2007, 04:12 PM
hmm it will be hard to solder in there

headless
07-12-2007, 04:13 PM
Yep. Be careful not to melt the insulation on the wire too much... it's clear, but it's there! soldering iron, i would recommend 25 watt for that. needle tip. Can you not solder from the opposite/far side of the board?

scotsman
07-12-2007, 04:16 PM
don't believe i can take the board off

headless
07-12-2007, 04:21 PM
****, wtf.

scotsman
07-12-2007, 07:53 PM
****, wtf.
it was glued in, but i took it off and soldered it from behind, now works like a champ. Thanks :thumbupw:

headless
07-12-2007, 11:46 PM
rock on - good job man. I was hoping it'd be screwed down - glue is pretty ghetto. Looks like you got the job done though. Good one m8.