2 S12l7 subs need a box

[dtmccray]

Where can I find a box design for 2 S12l7 subs (limited space) approx W29xH13xL19 inches can go further on L if needed.Would like to keep it as small as possible to save hatch space.

[spoonraker]

read the stickies, it really is a lot simpler than most people think

[dtmccray]

stickies?

[dtmccray]

tried WinISD alpha, I'm lost

[05gliguy]

I'm guessin you're going to make it sealed to save on space?

[dtmccray]

From what I've read sealed is no good for these so I guess ported

[kpozr2]

sealed is fine. ported is where they really shine.

[dtmccray]

Any ideas on finding a box design

[dtmccray]

What are approx outside dimensions of your box

[rpfuror]

WAY to small for 1 driver ported... maybe to small for both seal (never tried).

The absolute best is 3.25 cu/ft @ 33hz ( with to many boxes to mention in testing )

[dtmccray]

can go bigger need to measure to be sure of how much

[dtmccray]

going to measure be back shortly

[05gliguy]

my buddy has one 12 in 2.5 cubes at 45 hz and it sounds good for daily

[dtmccray]

w35xh16xL19 any longer on L and I would have to taper could go about 24 on a steep taper after 19

[dtmccray]

Not too far off from (po2)?

[05gliguy]

you could go ported with that... single chamber for both with one port to save space

[rpfuror]

that will work you can do ~ 4cu/ft gross @ 34 Hz and it will do very well.

[dtmccray]

U wouldn't have a print for that would you?

[NoSq]

that will work you can do ~ 4cu/ft gross @ 34 Hz and it will do very well.

Would this be optimal for the 15s as well?

[05gliguy]

6 cubes at 34 for the 15's

[rpfuror]

4 cu/ft @ 34hz for the 12's & 6 cu/ft @ 34Hz for the 15's would be the low end based on the driver parameters. Maybe another 1 cu/ft for each would be the "ideal" but that all depends on the car.

[dtmccray]

Looks like W35 X H16 X L23 is the biggest I can go about 6 cubes before port prefer one long port on the top or front over an end port