PDA

View Full Version : Measurements for ext cab S10



skullsmasher
04-13-2007, 04:59 PM
If anyone has some please post em up so I can compare.

I haven't made the port measurements yet but here is what I have so far.

3/4 mdf:
45"x27"
45"x7"
45"x15"
45"x3"
45"x8"

Does anyone have suggestions or any comments about this size of a box for a couple (Maybe 3) 12"s ?

What should I use to prevent rattling if any occurs? Where should it go usually? I know it depends where it rattles from but, I am just not sure how to do it so any help is appreciated. Should I bolt it to the cab?

Flipx99
04-13-2007, 05:02 PM
You can actually make the width 46.75 inches.

Keep in mind there is a jack stand that you may have to cut out.

Also, if you don't want it to go higher than the carpet on the back, your measurement is 12.5

skullsmasher
04-13-2007, 05:04 PM
You can actually make the width 46.75 inches.

Keep in mind there is a jack stand that you may have to cut out.

Also, if you don't want it to go higher than the carpet on the back, your measurement is 12.5

Cool, thanks man. I was actually gonna go all the way up to just below the windshield so I can add 1-2 more woofers when I am able to.

the box is gonna be ok though if I just "throw it in there" ????

skullsmasher
04-13-2007, 07:39 PM
tryin to do this http://www.caraudio.com/gallery/2/4/6/6/1/IMG_0713.JPG

skullsmasher
04-13-2007, 08:36 PM
or this but not so tall http://i18.photobucket.com/albums/b132/squeak12/Cody004.jpg

skullsmasher
04-13-2007, 08:39 PM
Should I go sealed or ported ?

skullsmasher
04-13-2007, 09:10 PM
bump

skullsmasher
04-13-2007, 09:11 PM
would this be a good way to port it ?
http://www.caraudio.com/gallery/1/5/1/4/2/PortedBox.jpg

skullsmasher
04-13-2007, 11:36 PM
bump :(

bjfish11
04-14-2007, 10:12 AM
Here is a box Chris (IonSQL) designed for a 99 ext cab s10. I will start building on this today probably. Should be fun.

http://i171.photobucket.com/albums/u282/bjfish11/bud1.jpg
http://i171.photobucket.com/albums/u282/bjfish11/bud2.jpg
http://i171.photobucket.com/albums/u282/bjfish11/bud4.jpg

skullsmasher
04-14-2007, 02:13 PM
Here is a box Chris (IonSQL) designed for a 99 ext cab s10. I will start building on this today probably. Should be fun.



cool, i need the measurements for the lip....the part where the floor bends or whatever.