PDA

View Full Version : port distance



bryce-man
04-04-2007, 12:30 AM
was wondering what was more important the space between 2 ports on the same baffle or the space between the wall and the port

both ports are flared

(im thinking #2)
thanks

bryce-man
04-04-2007, 12:39 AM
short little question here

Immacomputer
04-04-2007, 01:01 AM
Your question isn't very clear. What part of the port are you talking about? Also, is it hard to wait more than 9 minutes for a response? This isn't a chat room.

Immacomputer
04-04-2007, 01:03 AM
Oh my God, I just asked a simple little question for you to clarify. What's with the delay!??!

bdawson72
04-04-2007, 01:03 AM
You lost me slightly

quakerroatmeal
04-04-2007, 01:09 AM
Oh my God, I just asked a simple little question for you to clarify. What's with the delay!??!


Haha I laughed at this. Reverse questioned.

bryce-man
04-04-2007, 02:10 AM
haha well my last little question wasnt answered/ replyed to after it got off the main page lol
what i was asking was

ive heard of the rule that you have to have your port one diameter away from any wall
but what about the distance between ports.. does that need to be at least one port diameter or does it matter
talking about round ports ofcource

thanks
again

Immacomputer
04-04-2007, 01:01 PM
This is speaking about the rear of the port, not so much the side.
http://i14.tinypic.com/48womep.png

The red dimension is what matters, not the blue. You should also keep the butts of the ports away from each other as well as the wall. It's ok for them to be side by side but face to face. Having the port directly against the side of the wall will not do much but maybe add a small amount of port length (like maybe less than an inch). Having them too close to the back will cause a choke point though.

bryce-man
04-04-2007, 11:08 PM
cool thanks
just what i wanted to know