PDA

View Full Version : Who has experience with rl-i8 enclosures?



boomintahoe
04-02-2007, 11:16 PM
Looking for someone that can design me a good box for 2 of the subs above. See my other topic in subwoofers section. Mike @ Soundsplinter says to port them @ 33Hz. So porting them is what I want...venting, whatever. I don't want to use round ports at all....just either a square type vent or long rectangle vent. Enclosure calls for 1.3 cubes internal. Here's what Mike emailed me with:

A vented box on the RL-i8 should stand around 0.65 cu ft per driver, tuned around 33 Hz for in-car use. One 4" round port per driver would be best.. though of course, with such a small net volume, and a relatively low tuning, the port will have to be darn long. Therefore, I would suggest using a shared chamber between the pair of RL-i8's (for a total 1.3 cu ft net volume shared), and perhaps a single 5" round port (or a slot port with dimentions that offer at least 10 square inches of port area). To calculate port length, I would suggest using the following form (the second one on the page, ignoring the minimum usable vent diameter form):

http://www.carstereo.com/help2/Articles.cfm?id=31



If someone can do this for me, there's a small paypal fee I'm willing to pay :)

PV Audio
04-02-2007, 11:36 PM
I've designed me a few RL-i 8 boxes. PM me if you're still interested.

boomintahoe
04-03-2007, 10:18 PM
pm sent