PDA

View Full Version : 1st gen single cab s10



btlking
04-01-2007, 02:03 AM
im building a box for my friend but his truck is in the shop does anyone know the max dimensions i can use or have a box design for 2 12s for this truck?

Blove1991
04-01-2007, 02:06 AM
Hmmm,, not sure on the 1st gen but Im was able to pull out 4.1 cubes without displacements in my 2nd gen S10

btlking
04-01-2007, 02:08 AM
did you lose any clicks on the seat because he barely fits in the truck as it is?

the max width is like 54 i think

btlking
04-01-2007, 12:51 PM
any ideas?

ballstothewall
04-01-2007, 01:22 PM
When I had two ported 12's mine was somewhere around 12x18.5x40 and the final volume ended up somwhere around 4 cubes.

krisfnbz
04-01-2007, 01:24 PM
Go take measurements of your friends truck even if its in the shop, it takes like 30 seconds!

btlking
04-01-2007, 01:26 PM
i would but its over 2 hours away
ill just wait until it comes back.


for the people with a s10 or single cab for that matter wheres the best port direction i thought about firing it to the side is that a good idea?

kickerlivinloud
04-01-2007, 01:59 PM
i would but its over 2 hours away
ill just wait until it comes back.


for the people with a s10 or single cab for that matter wheres the best port direction i thought about firing it to the side is that a good idea?

Firing directions depends on the box. If your building a wedge like box to fit to the contour of the seat I'd say fire to the side. If your building it another way fire it into the seat if you have the room.





Jon

btlking
04-01-2007, 02:05 PM
it will be slant with a double front baffle so they dont hit the seat when playing