PDA

View Full Version : a few questions



04_edge
03-31-2007, 11:50 PM
well i started my box today for my 15" btl fully loaded, and i almost finished it (i had to work 1-9 today)

my sub is going to be facing forward, and im kind of worried that the basket might break, or that it may mess the box up.

i didnt double baffle it today, but tomorrow i am going to, im more worried that when i hit bumps and stuff the sub will torque the box and break the screws.

also, is there a way to build a support for the motor, i was thinking just building a half circle out of mdf to fit under it with some sort of support to hold it up...

04_edge
04-01-2007, 12:05 AM
bump

04_edge
04-01-2007, 02:39 AM
bump again, i really want to finish the box tomorrow....

dumple
04-01-2007, 02:40 AM
sure u can add a little support thing in there i made one when i had my l7

skadude016
04-01-2007, 02:46 AM
i really doubt you will break the screws. as long as they are tight and the box is solid :)

04_edge
04-01-2007, 03:22 AM
this is the box

4.5^3 at 34 hz 67.5 square inches of port

got a little to glue happy :/ but im going to sand all that off tomorrw, my hand were covered in it, i used gorilla glue :fyi:

http://i12.photobucket.com/albums/a232/in_tragedy/100_2504.jpg
http://i12.photobucket.com/albums/a232/in_tragedy/100_2503.jpg

Trixter
04-01-2007, 11:29 AM
you will not break the box. if your worried about it, double baffle the front. you had a good one by saying to build a small 1/2 circle brace to support the magnet.

mazdakid
04-01-2007, 11:36 AM
gorilla glue on hands ftl