PDA

View Full Version : Coax Type R 6x9



hemirunner426
03-23-2007, 03:12 AM
I have a set of 2005 Type R 6x9's that use a passive crossover along the terrible wiring they give from the factory.

Normally i wouldnt have a problem with this, however the wiring is soldered to the crossover box... terrible.

I have been thinking about doing an active setup with my MRP-F240 & my 9853.

I have a couple of questions... first off... would it be worth the effort of going to an active setup as far as sound quality? In my mind, i imagine i would end up with some cleaner high's.

second question... where the hell would i start off for crossover frequencies and slopes?

I was thinking around the 2-3khz range as a 12db/o slope? Am i correct in assuming this would be a good place to start?

Thanks for any info!

hemirunner426
03-24-2007, 03:49 PM
any help out there