View Full Version : Jeep Exhust Question

02-01-2007, 06:50 PM
Anyone know if you can run duals on a 97 model GC 4.0 litre?

02-01-2007, 09:24 PM
u can run duals on any car/truck if your going with custom piping. are you looking for a dual setup that u can bolt on?

02-01-2007, 09:34 PM
yea, ebay might have a exhaust system for it, if not try www.4wheeldrive.com

02-03-2007, 12:38 AM

02-04-2007, 11:27 PM
Just go to your muffler shop and tell them what you want.

W8 a minute
02-06-2007, 09:29 AM
You can but it sounds like butt crack. Someone had that on a Wrangler in my old Jeep club. IIRC most Jeeps built in the '90s had 2 downpipes off the manifold. It's tempting to cut and weld duals from there....but don't because you'll waste a lot of money for nothing.

02-06-2007, 02:55 PM
Its tough with the 4.0 and sounds kind of loud and raspy. If you just looking for addd performance and larger anftermarket or custom single pipe may be better

03-07-2007, 02:53 PM
I know this thread is old but I want to get a single in dual outlet flowmaster. Would this work and is the inlet part offset or center or what? Also what size is it 2.25/2.50? I wanna go ahead and get this muffler but im not sure of the piping sizes and if it will work, thanks!

03-07-2007, 07:44 PM
you can get a single in and dual out but your going to need it done at a exhaust shop so its done correctly... im sure it wont be that much just go around and ask local shops...