PDA

View Full Version : Mounting Depth Problems



Blove1991
01-28-2007, 09:15 PM
Does anyone know of ne good sites to find out the mounting depth of a box?

I plan on building a truck box with the specs of
Width: 50
Height: 28
Top Depth: 3
Bottom Depth: 9

And Im trying to figure out my mounting depth so I can figure out what im working with...and this is cutting the sub hole as low as possible to get the most mounting depth.


Thank You

icpurplepplalot
01-28-2007, 10:33 PM
the depth is how deep (long) your making the box

Blove1991
01-29-2007, 07:23 AM
So if i cut 9 at the bottom and make the subs holes close to the bottom and the sub will be angled due to it being a truck box I should have about what for mounting depth 6"??

Team Hammer
01-29-2007, 08:47 AM
Get a .90cent protractor and draw it out, Then you will know.

This is were math saves your wallet and time.

Blove1991
01-29-2007, 07:34 PM
Lol....Unless ur math is bad but Ill try

Blove1991
01-29-2007, 09:03 PM
I pretty much figured out everything that Im going to do and the sub I plan on getting only calls for 5 inches of mounting depth which Im sure I can fit


Thanks To Everyone