View Full Version : Easiest way to cut a triangle?

01-13-2007, 02:35 PM
I'm planning on building a triangle shaped box so that I can try placing it in different spots around my trunk. Here are some MS Paint sketches of what I'm going for.

I've never built a box before so these questions might seem basic.

The plan is to put the three sides together and then attach the top and bottom to them. I would start by attaching sides 1 and 2, and then attaching 3 to those. Which way of cutting it do you think would make for the easiest assembly?


01-13-2007, 04:50 PM
Option 2 will allow you to clamp panel 3 without it forcing the other 2 panels out of alignment. If you put braces on the end panels, you can assemble the ends to the box and have them hold it all together. That will ensure that the 90 deg angle is accurate and will give you a way to screw the whole thing together.

01-13-2007, 04:53 PM
45 90 45?

01-13-2007, 05:28 PM
that would be correct...... gunna have to be a rather large box though....

01-13-2007, 08:22 PM
that would be correct...... gunna have to be a rather large box though....
I don't think It'll be too bad. Here's a pic of the internal dimensions laid out with paper.

http://img215.imageshack.us/img215/2396/triangle2vb7.jpg http://img215.imageshack.us/img215/3531/triangle5hg2.jpg

01-14-2007, 02:28 AM
option 2 i like. allowing you to clamp across to the 90 degree joint. as for cutting that triangle piece, a water jet would be nice:) , otherwise use a jig saw

01-14-2007, 02:40 AM
Table saw FTW

01-14-2007, 11:18 AM
a water jet would be nice:) , otherwise use a jig saw
Totally unnecessary to use either. A table saw with a miter guide will cut a 45 for the end piece without a problem.

01-14-2007, 01:18 PM
I've got a circular saw, so hopefully I can make do with that.

01-18-2007, 11:39 AM
looking at the water jet technology that ive never heard of until now, it seems to be a pretty kick *** thing.

id like the oppurtunity to see it done

01-18-2007, 02:32 PM
Option 2
Glue and screw the 90* joint and while the glue is drying glue side 3 to the legs.align the three and use two band clamps to hole the whole thing togather. But it between two boards pointing down and put some weight on side 3 too. Glueing it will keep you fomr hanvingto fandangle with screws with an odd angle and will be plenty strong. Making sure the 90* angle is actually 90* is of most importance. The rest can be fixed with a router. :laugh: