PDA

View Full Version : check these **** things out...



SPL140.2
01-03-2007, 03:34 AM
^^^^^http://www.spiralfittings.net/standard%20bellmouth.htm

supa_c
01-03-2007, 03:44 AM
prices ?
only problem i see is they would dent very eaisly

Eugenics
01-03-2007, 03:48 AM
ducting eh? im sure its very cheap which is a plus.

SPL140.2
01-03-2007, 03:53 AM
prices ?
only problem i see is they would dent very eaisly

dont know of any prices but im sure you could add some resin or fiberglass to make it stronger

supa_c
01-03-2007, 03:58 AM
resin wont stick to metal, cmon now..

SPL140.2
01-03-2007, 04:00 AM
it will if you sand it with 60 grit ;)

PowerNaudio
01-03-2007, 06:20 AM
they look promising, i guess one way to find out if they are structurally strong enough for our purpose is to buy a set and put them to use.
and they come in all sort of parameters.

BASSMEKANIK
01-03-2007, 06:33 AM
square-o-port ftmfw!!!

Duke
01-03-2007, 06:44 AM
prices ?
only problem i see is they would dent very eaisly

Why would you subject them to being dented? Do you make a practice of denting things?

PV Audio
01-03-2007, 09:44 AM
How thick are they? If they're the size of the things on the side of your house, that's incredibly thin, would potentially flap around like a limp **** without reinforcement, and would dent like supa said.

ramos
01-03-2007, 09:50 AM
They would have to be really , really cheap to offset the extra cost of reinforcing them . Otherwise it's just as cheap to make them out of PVC :)

ramos
01-03-2007, 09:50 AM
resin wont stick to metal, cmon now..



Epoxy will with a little prep work :)

THUNDERBIRD
01-03-2007, 10:00 AM
you can just make a thick *** fiberglass mold of it.

dbornotdb
01-03-2007, 11:17 AM
Available in most sizes in aluminum, paint grip, and stainless steel.

Thats off the site. I don't think they will dent quite as easy as you may think.

xluben
01-03-2007, 01:03 PM
48" flared port? that'd be interesting......

the 8" (inner diameter) round flare weighs 2 pounds, so it can't be too thin.

ramos
01-03-2007, 01:06 PM
I wasn't thinking of using them for ports, they would probably make a pretty good flare mold :up2somet: PVC softens a whole lot cooler than that smooth, perfectly shaped metal flare ever will. And 10' of 6" PVC is $11 and 4" is $9 :)