PDA

View Full Version : Need A Box Design For A Regular Cab S10



Bumpn Focus
12-25-2006, 02:37 PM
Im new to the caforums but not new to car audio forums in general. was wondering if i could get a simple box design for 2 10" Memphis PRS Single 4ohms. Dude's gonna be running a Memphis 500D.

Dimensions we have to work with 51"Wx13"Hx6 1/2"D


Dude doesn't want a slanted box, so thats max dims we can do for depth. We're gonna have both subs as far over on passanger side as possible with a "L" port firing out driver's side.



Just need some measurements of the box and port length and width.


Any help would be greatly appreciated. Thank You!

xluben
12-25-2006, 05:27 PM
i just designed a ported box for a regular cab s10. do a search and you should be able to find some stuff.

without slanting the box, you're either going to lose TONS of leg room, or else there's no way you can port two 10's.

i managed to get about 1.8ft^3 tuned to 35Hz for a single 12".

that was 48" wide, 22" tall, 10" bottom depth, 2" top depth and a 6" wide 2" deep notch for the center console. the port was 3"x7" and 21" long (if i remember all of those figures correctly.

whatever you decide, i think your plans are going to have to change drastically.

bdawson72
01-05-2007, 07:01 AM
whose car are u putting that in