PDA

View Full Version : Need Ideas for an Rl-i 8" in an IS300



ItalynStylion
12-04-2006, 11:55 PM
An Rl-i 8" is going to be going into my trunk soon and I need some ideas for a box. I'm not in a hurry as I will order the sub once I get the box plans all laid out. I would like to port it since it will be one lonely 8 and I don't want to skimp on the output. The soundsplinter website said that it should be about .4-.6 cu ft.

Here is a picture of the sub with its dimensions
http://www.soundsplinter.com/images/graphs/rli8-measurements.jpg

Now the tricky part is that I have this odd little hump in the trunk that is the top of the fuel tank so drilling there is a no no... The hump in the picture is 19" wide.
(keep in mind that my PPI amp is on the backseat too)
http://i17.photobucket.com/albums/b75/ItalynStylion/Stock%20IS300/trunksetup001.jpg

Now I'm sort of a symmetry freak and I would like to put something right in front of the amp in the middle. I want it to be as short as possible but it can be as wide as needed.

I'm open to all ideas:)

ItalynStylion
12-06-2006, 12:55 AM
Bump for some much needed ideas/help...

bdawson72
12-06-2006, 12:57 AM
IS300 are teh butsecksiness:fyi:

DjiNN
12-06-2006, 12:59 PM
what im thinking is building a box that takes the hump/bump into account .. and build a slot over it .. i will try to draw pics if needed ..

j3bus2k3
12-06-2006, 01:06 PM
I was going to mount 2 8"s in my rear deack and build the box down into the trunk...maybe it'll work for you...