PDA

View Full Version : Can someone explain port noise?



Pl8er
12-03-2006, 01:38 AM
I searched port noise but just get a ton of threads saying "hope you enjoy the port noise" or "your going to have port noise" etc.

what is port noise? What causes it and what does it most sound like, other than the obvious which is port noise :P

Thieroff
12-03-2006, 01:40 AM
Port noise sounds like a whooshing or high velocity air coming thru the port


Caused by too short of a port

haha, hook it up and see man, you'll know


CT

Pl8er
12-03-2006, 01:43 AM
Most of my boxes I have had were sealed, never had to worry about it.

Thieroff
12-03-2006, 01:45 AM
just install it man, and dont worry about it

If its there just build again, or get used to in, nah mean?


CT

xluben
12-03-2006, 01:49 AM
Caused by too short of a port


wrong :(

coolahan
12-03-2006, 05:53 AM
wrong :(

YAH MOMMA

supa_c
12-03-2006, 05:54 AM
W7's are wooshy even in sealed enclosures. I guess they need better pole piece venting

SHiZNiLTi
12-03-2006, 06:14 AM
I've got a lil because I didn't round the corners of each port....
http://img300.imageshack.us/img300/9250/28hzcp1.jpg

BassAddictJ
12-03-2006, 07:23 AM
i had a box liek that and didnt round those corners,........mine was fine :) mine was 4 cubs @ 28Hz....same number of port turns inside too...

PV Audio
12-03-2006, 11:35 AM
Port noise is caused by too small of a port width. The air caused by the speaker thus creates more velocity in said port, which causes the fluttering sound you hear.

helotaxi
12-03-2006, 11:37 AM
It's caused by turbulence in the port as a result of either sharp edges on the port or too small a port cross sectional area for the volume of air moving though it. Smaller area equals higher velocity equals compression of the air and noise. Compression will also cause the air to "pack" in the port and change the tuning as well. In an SPL setup it will cost you output. The fix is to make a larger (cross sectional area and also length to keep the tuning the same) port.