PDA

View Full Version : Audi sound deadening Q's?



skibumdc
11-15-2006, 01:34 PM
NOTE: I have already read the STICKY on deadening the door.

Ok, so I previously installed Polk Momo's 6.5 in the door of my 06 Audi on the plastic spacers.
About to swap those spacers for 3/4" MDF and clay it up...and I want to sound deaden the door as well.

The door from the factory already has some insulation on the inner door panel facing into the cabin...do I remove the old factory deadening and install the new deadening material then stick the factory stuff back on? Or get rid of the factory stuff altogether?
Only if I remove it will I see how sealed the door is...I'm betting the factory deadening is not tightly sealing the door since my midbass is not tight.

It's not a vapor barrier, it's foamy.

Thanks all.

skibumdc
11-16-2006, 09:05 AM
Bump

ItalynStylion
11-16-2006, 04:29 PM
I would say that if you have to take the stock deadener out to apply the new stuff I would just throw it out and add a second layer of the good stuff :)

PremierAudio
11-16-2006, 04:59 PM
The factory "deadening" is basically a sound proofing material. Not a mass loading material that most people call sound deadening. It helps keep out unwanted road noise and such. Add your deadening material and keep stock material.

skibumdc
11-17-2006, 01:58 PM
Thanks guys.