View Full Version : Pioneer REV Component Set
11-10-2006, 03:00 PM
What is the dimensions of the crossovers?
Search gives nothing. Contacting Pioneer gave nothing as well.
11-10-2006, 03:13 PM
What model? The TS-C160R crossovers measure 102x76x30mm.
11-10-2006, 03:16 PM
Thats the one. Thanks much man.
That's H X W X D, correct?
11-10-2006, 03:27 PM
Here ya go:
Listed as mm (in)...
11-10-2006, 03:32 PM
Sweet. They are a little smaller then I was thinking.
I'm building an amp rack which is also where the crossovers will go, but I havn't got them yet so I didn't know the sizes.
Thanks for the info.
11-10-2006, 03:36 PM
Not a problem bud. Good luck with the fab and install. Post pics when it's done!
11-10-2006, 03:40 PM
Yea I will. The only thing sucky about putting crossovers in the back is using twice the wire. But this thing is going to be off the hook when I get it all together. It will be much better then my ghetto setup now. (look at sig links for pics)
11-10-2006, 03:59 PM
Ya know, your current setup is still better looking than about 75% of the installs I see. LOL
11-10-2006, 07:49 PM
How are the crossovers secured? I dont see any mounting brackets on the pics.
11-12-2006, 12:20 PM
I just started the same TS-160R componets yesterday, and I know what you mean about the double wire to the trunk. I'm gonig to stick both of mine (crossovers) in my glove box I think or somewhere up front and just run the 1 set of wire to the amp itself. As for the mounting of the crossovers, the top pops off (plastic) and then you can secure the base of them to wood or just whatever. Do post pics, and I'll ssee if I can do the same once my project gets closer to completion.