PDA

View Full Version : Active Crossover vs Passive



tbonephile
11-08-2006, 11:40 PM
I have a set of A/D/S 346cs that I got on Ebay and I'm taking it to the shop this weekend. My installer has a Audison LRx4.300 that I'm buying from him for half price and I was wondering should I run these to the components at bridged at 210x2 (Speakers are 125 rms) or bi-amped at 65x4. If I biamp, should I go active crossover or use the passive crossovers that came with it? Whats the man difference with an active setup besides tunablity? I'm installed these in the factory stock locations of a 07 Audi A4.

JimJ
11-08-2006, 11:43 PM
There's no sonic difference between the two...but the tuneability alone is reason to do it :)

Might as well go active.

iceteebone
11-08-2006, 11:44 PM
i guess the first question is do you have an active xover?

tbonephile
11-09-2006, 12:01 AM
The Audison has a lot of stuff to play with in regards to the crossover

computerparts
11-09-2006, 11:01 PM
If you run active then you have to run the amp in 4 channel mode which means less power.

DefiantGSR
11-10-2006, 12:05 AM
active

Notwerk
11-10-2006, 12:42 AM
That all depends. The passives might well do a good job. On the other hand, you might do better going active. Depends on how much time you want to spend tweaking. Personally, I don't see a point in bi-amping through a passive. If you're going to do that, might as well go active and get some advantage out of it.