PDA

View Full Version : Plotting a curve for a new enclosure?



Bake
11-08-2006, 11:23 AM
When using programs to plot a curve for a new inclosure do most of you go for a smooth roll off or do you tune for a little rise near the tuning frequency?

Beat_Dominator
11-08-2006, 11:54 AM
I personally like to tune for good low-end extension, if that creates any peaks up over 60hz or so I can just eq it out.

Bake
11-08-2006, 05:04 PM
Thanks Beat. I have it flat down to around 40 on the box I am drawing up now. I figure with cabin gain in the SUV that it is goinig in it should sound good and have decent output as well.

JimJ
11-08-2006, 05:06 PM
Very difficult to predict what it's going to do in vehicle...computer modeling only goes so far.

lilmaniac2
11-08-2006, 05:07 PM
Bah who says so jim... i hear next year db drag just gonna have u email in box designs to see whos the loudest... cuts out the over head

Bake
11-09-2006, 01:08 AM
Thanks guys, I know modeling only goes so far. Just curious where most of you guys start. It isn't going to be anything major anyway. Just throwing something together for a friends kid.

Oh, and Jim, very nice avatar.