View Full Version : Port questions

11-05-2006, 01:35 PM
OK I designed the box with a cad program and another program cant remember the name but it was highly recommended. Anyways that was a while back, for the life of me I can not find the paperwork I printed out for it. And since then my hard drive crashed and I lost everything. The box is going to hold an 06 XXX. Its built to 2.2 cu ft and it will be 35 Hz If I remember right it was going to be a slot port, but I think I ran into some problems and was going to go with aero ports.

here is the thread on the box...


As you can see the box is not square, which makes it a little diffcult. It tapers in.

I am about ready to get started on the port and am stumped! Any suggestions?


11-07-2006, 06:58 PM
anyone? or is this just something i have to figue out on my own?