PDA

View Full Version : Quick fiberglass ?



heyman421
10-20-2006, 05:19 PM
Is fiberglass resin a good adhesive for mounting finished fiberglass pods to plastic door panels?

Simple question, just wasn't having much luck searching.

And what about using resin for upholstering the enclosures? Should i use a contact adhesive instead?

Thanks guys.

MrSwiss
10-20-2006, 05:23 PM
the resin doesnt bond with plastic. there is some special stuff i need for that.

Megalomaniac
10-20-2006, 05:26 PM
if you hot glue the mold then fleece the whole thing, it will work

Big Dee
10-20-2006, 05:31 PM
if you hot glue the mold then fleece the whole thing, it will work

:confused:

Fleece what? the entire door panel?

Megalomaniac
10-20-2006, 05:33 PM
nvm i was thinkin kickpanels

heyman421
10-21-2006, 02:17 AM
i didn't get that far anyways tonight, i'll figure something else out for tomorrow.

thanks guys

Rawr-DQ
10-21-2006, 11:57 PM
I would say, take some 80 grit sand paper and rough up the plastic you're trying to attach it too...and drill holes in the panel so that kitty hair or resin can hold onto the plastic a little better.