PDA

View Full Version : what tweeters with these mids?



southwest713
09-15-2006, 12:06 AM
i'm looking to get some AA poly mids. i was thinking 2 in each door in door pods.
which tweeters or crossovers would i need to make it sound good?
i listen to rock/rap if that makes a difference

specs on mids:

Znom 4 ohms BL 5.43 n/a Cutout diam. 5 13/16
Re 3.2 ohms Sd 140 cm2 Outer diam. 7.00
Fs 46 Hz Mms 16 g Mounting depth 3 3/16
Vas 20.8 L Xmax 11.5 mm Weight 2.6 pounds
Qms 2.714 Spl 88 dB 1W/1M Voice Coil diam. 1 1/4 inch
Qes .501 Rec. Power 25-100 W Voice coil 4 ohm
Qts .423 Rms 100W Cone Curvilinear Poly
Le .05 mH

UndercoverPunk
09-15-2006, 12:08 AM
The Vifa XT25's that come with the poly's in the arbiter TM kit are excellent for the money.

southwest713
09-15-2006, 12:18 AM
The Vifa XT25's that come with the poly's in the arbiter TM kit are excellent for the money.

where would i be able to get those?

nvm found them

UndercoverPunk
09-15-2006, 12:24 AM
where would i be able to get those?

nvm found them

;) good stuff.

southwest713
09-15-2006, 12:29 AM
so would the poly mids, the vifa xt25s, and a 2-way crossover crossed at 3khz work good? or should it be crossed higher or lower?

UndercoverPunk
09-15-2006, 12:33 AM
so would the poly mids, the vifa xt25s, and a 2-way crossover crossed at 3khz work good? or should it be crossed higher or lower?
That wouldn't be bad at all. Although it depends on if the sensativity of the two is the same, some level matching may be needed when running passive. I wouldn't know.

flakko
09-15-2006, 04:23 AM
i would drop the xover point a little more...

supa_c
09-15-2006, 04:32 AM
I just cranked the **** outta my XT25, my god did it get loud and didnt break up at all.

squeak9798
09-15-2006, 07:51 PM
Are you planning on going active or passive ?

MrSwiss
09-15-2006, 09:16 PM
I just cranked the **** outta my XT25, my god did it get loud and didnt break up at all.

hah makes me wish i had splurged for the whole component set!