PDA

View Full Version : Take a look at this please



pwnt by pat
09-12-2006, 09:33 AM
It will be close but should fit.

btw, When you make/get cut sheets, have everything in inches It's much easier to work with when using the imperial system.

DaGh0st
09-12-2006, 09:37 AM
is the front 28 1/2 inches? cant reall see i just woke up. Should have plenty of room

nVRuckus
09-12-2006, 09:48 AM
should have room. I just put 2 15s in a box 34" wide and it left room ;).

nVRuckus
09-12-2006, 09:50 AM
ahh your cutsheet is confusing. your fuxored. 12" subs are more like 13" OD

MisterGrubbs
09-12-2006, 09:50 AM
yeah you're going to be friggin pushing it

Wow, what a difference another inch would make

nVRuckus
09-12-2006, 09:55 AM
side port or top mount FTW

DaGh0st
09-12-2006, 09:58 AM
errr geez i dunno bro its gonna be close. Look at my Aviator the face was like 25 1/4 or something but it Barrely fit i hope your subs dont have a big mounting lip like the type r's

nVRuckus
09-12-2006, 10:01 AM
errr geez i dunno bro its gonna be close. Look at my Aviator the face was like 25 1/4 or something but it Barrely fit i hope your subs dont have a big mounting lip like the type r's
LOL yeah I was surprised @ the type R for the project im doing now. 3/4" deep lip and wide a hell.

nVRuckus
09-12-2006, 10:08 AM
flip the port to the side not the back. you can run a straight port frm left to right no turn needed.

nVRuckus
09-12-2006, 10:09 AM
and length is top to bottom depth is front to back

nVRuckus
09-12-2006, 10:33 AM
you make the port the same length and width as before you just use a straight piece instead of 2 pieces in an L ;) and dont forget the shortenthe side to make the hole for the port.

add the 2 lengths of the port before and thats the length of the 1 piece now.

xluben
09-12-2006, 10:35 AM
you can only do that if you have enough room to the side of the trunk for the port to fire out.

and if you have that much room you might as well make the original box design wider.

also, even though the front panel is 24.75" you'll have 0.75" more width due to the piece on the side. that'd give you 25.5" wide to work with, and since DaGh0st got his Type R's to fit on 25.25" i think you'll be ok!

nVRuckus
09-12-2006, 10:37 AM
I dont think 25.5 is enough to put both 12" type Rs with the rubber on them. I think they are wider than that.

mazdakid
09-13-2006, 07:05 PM
what kind of car? take the rubber rings off the subs to make em a little smaller