PDA

View Full Version : d661s x over



jasperpso
07-26-2006, 12:16 AM
http://www.users.qwest.net/~photovisions/d661s%20xover.jpg

here is a pic of the crossover included with the diamond d661s component set.

why are there 8 terminals?? +/- from amp to xover, +/- from xover to tweeter, +/- xover to woofer.. i am confused, i thought components only required a 2 channel amp? what are the other two termnals for?

Prowler573
07-26-2006, 12:18 AM
Are two of the terminals marked RAF?

jasperpso
07-26-2006, 12:19 AM
i dont have em yet. just looking at a picture and was confused..they were shipped and i have a tracking number, so they are on the way, now i am just waiting....

what is RAF?

Prowler573
07-26-2006, 12:20 AM
Rear Acoustic Fill

jasperpso
07-26-2006, 12:30 AM
ok, so what why would the comp. xover have those outputs?

Prowler573
07-26-2006, 12:33 AM
I do not know if it is a function of any other brands of components but it is a feature included with DAT's components.

jasperpso
07-26-2006, 12:35 AM
is it for a third speaker.. i am trying to understand why u are being so vague..

Prowler573
07-26-2006, 12:36 AM
Because I do not completely understand it myself, to tell the truth. I just know the crossover modules for my components have an output for RAF but I do not use those outputs.

jasperpso
07-26-2006, 12:37 AM
ok, well i will assume that is what they are until i get them.. just thought it was weird that it had 8 terminals..

pimpedout97x
07-26-2006, 12:40 AM
i never understood my mine had that also.

6spdcoupe
07-26-2006, 02:35 AM
RAF is as stated...Rear Acoustical Fill. It gives the availability to run rear fill from That crossover while still only using a 2 channel amp. If your running rear speakers in your car, you can use that output to power them.

jacka
07-26-2006, 02:36 AM
is it for a third speaker.. i am trying to understand why u are being so vague..

if he knew he would've helped. but anyway, RAF is this:

Each D(x) component crossover has a third set of outputs marked "RAF." This stands for Rear Acoustic Fill. This output can be used to power an additional speaker off the same channel without effecting the impedance load on the source unit. This output allows 15-20% of the total power to the extra speaker and is unfiltered. However, due to the added series resistance the connected speakers low frequency output will be slightly damped. The effect is similar to a 6dB filter at approxiametely 200Hz.