PDA

View Full Version : too much shaking of doors the ceiling etc...how do i stop it?



alpine_sheer_SQ
05-27-2006, 12:41 PM
how do you pro audio guys stop home audio rattles?

i have a shity door and it rattles like a MOFO

the vent was really really nasty it would **** it air and rattle like a fat 8'' port lol

fixed the vent by scewing a piece of p board in front of the vent so it doesnt get any air to make it sound like shat....that worked like a charm

however the door is still a huge problem during lil jon or any really bassy **** it rattles like ****

should i get a used hardwood door so it stops the rattle sound? im thinking that would work

whats the basic guide to making a room ''boom able''

thanks guys

alpine_sheer_SQ
05-27-2006, 01:10 PM
dynamat or something like it.


ya that may work but would cost more than a used door at the store lol i could get a nice hard wood door would that cut out the shat?

PV Audio
05-27-2006, 03:52 PM
You'll probably need an acoustically treated room if you play all your **** to that level.

j3bus2k3
05-27-2006, 07:30 PM
You'll probably need an acoustically treated room if you play all your **** to that level.

:word: or do as PV's sig says and buy a 1000W amp :p:

PV Audio
05-27-2006, 10:15 PM
:laugh:

j3bus2k3
05-27-2006, 10:38 PM
I thought you'd like that ;)

joetama
05-30-2006, 01:36 PM
Does the door rattle against the jam? Because if it is just get some of that cheap roll foam that's sticky on one side and put a small layer in the door jam where it rattles.

i3abyjay25
05-30-2006, 06:42 PM
1/2 inch Mdf and dynomat.. what i did...

bballer123
06-19-2006, 12:28 PM
Does the door rattle against the jam? Because if it is just get some of that cheap roll foam that's sticky on one side and put a small layer in the door jam where it rattles.
Very simple and cheap option. Works great. I have used it in my car as well as in the house for rattles.

MrSwiss
06-26-2006, 08:11 PM
i shoved a couple bandanas under my license plate and in various areas of my car hehe

Brian Owens
07-03-2006, 09:31 AM
Is the door adjusted right? The stop plate should have a tab in it that you can adjust to make the door shut tight.

My wife hates that I have all the bedroom doors so they have to be pulled shut. No slack. . .but I hate to hear rattles!!!!

Brian