PDA

View Full Version : Yeah, Its a box ;)



Psyence
04-19-2006, 11:01 PM
Here is a new box I made for a buddy... Dual Chamber ported box for 2 12W7s, 1.81cuft per chamber (net), 32hz.

Just gotta put the ends, seal, and put on carpet, did the mouting holes after the pics.

http://www.battlepsyence.com/bradsbox1.jpg

http://www.battlepsyence.com/bradsbox/bradsbox2.jpg

http://www.battlepsyence.com/bradsbox/bradsbox3.jpg

Bolognablake
04-19-2006, 11:18 PM
Nice.

Looks smaller than 2ft^3 each though.

SAG3
04-19-2006, 11:20 PM
flush mounting?

SAG3
04-19-2006, 11:20 PM
****

Psyence
04-19-2006, 11:24 PM
I was going to flush mount. But unfortunately, the only way to do that is to make a removable baffle due to the way the subs are installed.... (Screws go under the surround, then a ring, then a clamp ring over that, you need quite a bit of room to put the clamp ring around the woofer... Hard to explain.

I may do it, just not quite sure yet ;)

JL12W7INAGS300
04-19-2006, 11:27 PM
****!

tommyk90
04-19-2006, 11:28 PM
Nice.

Looks smaller than 2ft^3 each though.

x2

Especially after factoring in the massive displacement of a W7

Psyence
04-19-2006, 11:44 PM
Ill edit my first post. I was excluding the sub displacement when I posted, included when building tho.

The exact size is

1.812cuft including all displacements. The gross size is 2.391cuft, port displacement is .439cuft, and the sub displacement is .14

Tuned to 32hz.

I think it looks a little smaller than it really is sitting on that table saw. The depth is 29" the peak height is 15.5" and the width for each woofer is 14.125"

Its pretty big, and **** heavy.

James Bang
04-20-2006, 12:37 AM
mighty ****... the box. very very clean cuts.

TheNoodPoopler
04-20-2006, 12:39 AM
where in canada you located man? im over in bc.

thats teh **** ;)

soul05
04-20-2006, 01:11 AM
wooooo very nice box

PV Audio
04-20-2006, 07:33 AM
I'm not seeing any dual chamber...

Pyro_By_Nature
04-20-2006, 07:38 AM
Now THAT'S what a box is supposed to look like!

Nice cuts ;)

And pv..........it's quite obvious that it is in the last pic ;)

ramos
04-20-2006, 10:03 AM
I'm not seeing any dual chamber...


I didn't either until I noticed the screws running down the middle, then the depth in the last picture. Looks nice so far man. Just a question, I see you didn't divide the port all the way. Isn't that going to mess up the tuning ? :)

joetama
04-20-2006, 12:11 PM
Now THAT'S what a box is supposed to look like!

Nice cuts ;)

And pv..........it's quite obvious that it is in the last pic ;)

I thought it was pretty obvious......