PDA

View Full Version : What would look good.



Silver
04-02-2006, 01:23 PM
How can I make this look better? I wanna keep it square and all. I just dunno wtf to use haha.

http://img113.imageshack.us/img113/5098/mvc010f1gu.jpg

Trixter
04-02-2006, 01:36 PM
check out my gallery....

basically, i did it in two pieces...left and right. i made pieces out of 1/4" hard board and carpeted them. they are fastened by 4 bolts on each. the bolts were fastened through the top, counter sink and bondoed into place. the hard board was them carpeted and then installed using pre drilled hole for the bolts. 2 pieces had to be used otherwise it wouldn't fit. i am thinking about covering the hole completely. the original idea was just to make my 6x9 holes to fit a 5 1/4.

MrSector9
04-02-2006, 01:44 PM
maybe build a small square frame out of small wood and thenstretch some grill fabric over it :) i woudl try that

Trixter
04-02-2006, 01:56 PM
that would look just fine....

thai_creeper
04-02-2006, 06:45 PM
what's that hole for?

Pop da Hatch
04-02-2006, 06:47 PM
Duct Tape FTW! :crazy: :naughty:

mikey060
04-02-2006, 07:37 PM
what's that hole for?

my guess would be for the port airflow:)

NickCR
04-02-2006, 07:59 PM
http://www.nicholasaron.com/misc/mvc010f1gu[1].jpg

Something like that should do the trick.

azbass
04-02-2006, 08:04 PM
fiberglass the whole thing. all of it.

Silver
04-02-2006, 11:12 PM
fiberglass the whole thing. all of it.

where are de tutorials! I'd love to fiberglass it.

ballstothewall
04-02-2006, 11:41 PM
Get some small weatherstripping and put it on the edge to clean up the edge a little.

Raisedin305
04-02-2006, 11:44 PM
Duct Tape FTW! :crazy: :naughty::rotflol: