PDA

View Full Version : Turning a 4 channel into a 2 channel



KyleScha
01-05-2006, 12:48 AM
Ok. This is probably a bit of a newb question. I have a JL300/4 and wondered what would happen if I ditched my rear speakers and made it 150x2.

So I just want to make sure what I did is effectively putting out 150 watts on each speaker.

What I did was bridge the two front channels for the right speaker only, and only plug in the right RCA. I did the same for the rear channel, except I bridged it using the left speaker only. I then plugged the left RCA cable into the left.

Now as long as I keep the gain and crossovers the same, is there anything wrong with this and am I getting 150 watts to each speaker?

Thanks.

KyleScha
01-05-2006, 12:53 AM
blah, i posted this into the wrong forum sorry

ToyTundra
01-05-2006, 12:28 PM
it may be a noob question, but you have the right answer. You are my favorite of all the members :clap:

There is nothing wrong with it at all.

squeak9798
01-05-2006, 07:06 PM
:2thumbs:

Sounds like you did a good job.

And yes, you are getting 150w per side.

KyleScha
01-06-2006, 02:03 AM
Thanks for the kind replies!

It sounds amazing!