PDA

View Full Version : new Diamond components - amp wiring help



Hartman
12-28-2005, 09:41 PM
So I just got a set of 6.5 Diamond D661s, this being my first set of components. 200w max. I also have an old Profile California amp laying around that I would like to use with these components. The specs on this amp are as follows:

100 watts RMS x 2 at 4 ohms
300 watts x 1 in bridged mode
150 watts x 2 at 2 ohms

I'm used to wiring subs, but with components I'm a little confused as to how I'm supposed to wire them. The mids are 4ohm svc obviously. How should I wire these to get max power out of them without damage?

The way I see it, if I just wire one channel to each crossover, each side will get 100w (theoretically), correct?

Hartman
12-28-2005, 11:32 PM
bump

azbass
12-28-2005, 11:37 PM
um, you use the amp in 2 chan mode, one chan to one comp, and the other chan to the other comp.

Hartman
12-28-2005, 11:41 PM
that's all I needed to know thank you.