PDA

View Full Version : What are the options to close up holes?



Intercooler
11-26-2005, 11:54 AM
I have a custom box for my Z-71 that by all accounts should be a sealed unit as opposed to being ported like it is now. It also has the round inserts at each end for wire connections. What options are there to seal up the two 3.5" diameter and two 2" diameter holes to make it a sealed unit? Would round pieces of Plexi applied across them with sealant and screws do the job?

MrSector9
11-26-2005, 11:59 AM
If the plexi is thick enough then that would work fine.

Intercooler
11-26-2005, 12:03 PM
Is that better than using MDF on the inside? Should I also cut a piece to the same size diameter to go in the whole? Just a piece to the inside?

MrSector9
11-26-2005, 12:11 PM
perosnnaly I woudl just use a peice of mdf ont he inside sicne it is cheaper nad oyu porlly have scraps around, seal and screw it on and it woudl be fine.