PDA

View Full Version : need help finding problem



trunkbanger
10-26-2005, 03:54 PM
i have 2 15" rockford fosgate hx2 first series ran down to 1 ohm but only pulling 2 ohm off ampliphier. i have a cheap 2000 wt nitro amp. i know its a piece a crap!
the other day i only had 1 sub working and i cant figure out why the other one is not working.i checked the channels all the wiring and everything is fine exept for me blowing the amp a day later. why wouldnt the other sub turn on? i honestly think that the amp fried something inside my sub i cant see. does anyone have a clue? please help me. these are my babies and im not done with em yet.
thanx,
chris

chris96camaro
10-26-2005, 03:55 PM
my first suggestion is BUY A NEW AMP....why would you run those good subs with a crap amp...i dont get it....

PhatTonyDeMarco
10-26-2005, 03:57 PM
You wont find a problem unless you have an amp to test it with. So get a new amp. Check your tinsel leads on that sub though, something might be disconnected...

trunkbanger
10-26-2005, 04:05 PM
i know bad amp great speaker but had a show b4 it got 2 cold. i checked the tinsel leads and everything looks fine... i just cant understand it. ne one have a 3ooo wt amp for sale? remember im running these at 1 ohm

PhatTonyDeMarco
10-26-2005, 04:07 PM
That amp didnt put anything near 3000w of power.

tplaya07
10-26-2005, 05:19 PM
You need to see if the sub is fried as well. Get a Multimeter, and see what the resistance is across the coils.

trunkbanger
10-27-2005, 10:09 AM
i know that amp didnt give me 3000, but thats what i need. i need more juice. these subs took everything that that amp could possibly give out which was probaly about 1600 x 2.
i honeslty think my voice coil is blown