View Full Version : winisd help

10-23-2005, 05:51 AM
ok im trying to build a box for a memphis sub and on there site i only get half of the specs i need. so where do i get things like pe, re, le, and Z i need pe for sure because in trying to find out my port speed so i can see if im getting port noise. thanks also the sub im using is a memphis m3 12 dual 4 ohm.

10-23-2005, 11:24 AM
The very minimum driver parameters that you will need are:
Vas = Equivalent air compliance (litres)
Qts = total Q of the driver at its resonant frequency
Fs = resonance frequency of the driver (Hz)

PS: welcome to the forum!