PDA

View Full Version : Tweets to match with RE Comps



abcheng
10-09-2005, 02:52 PM
I've had my RE Comps installed for a while but the tweets on them are too harsh for my taste. What tweets would you guys recommend to go with the RE comps? Should I get a pair of CDT tweets ?

Tempe
10-09-2005, 03:02 PM
Dayton silk 1-1/8" tweet is really smooth if you can fit it.....

Tempe

abcheng
10-09-2005, 05:29 PM
which one on PE's webpage? Also, is the crossover w/ the RE comps fine for it? How would I go about mounting it?

SSS 18734
10-09-2005, 05:30 PM
a user here on the forums replaced his with Aura tweeters and seemed pretty happy with them.

Personally, I think the RE tweets are just fine so I havn't bothered replacing them.

Tempe
10-09-2005, 07:13 PM
which one on PE's webpage? Also, is the crossover w/ the RE comps fine for it? How would I go about mounting it?

http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=275-070

This one is what I had in mind. No the 8 ohm impedence would give you a higher crossover point IIRC.

http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=275-035

This might work, but I am concerned about its ability to play down to 2khz....

Tempe

abcheng
10-09-2005, 09:02 PM
hmm alright. Would there be a huge noticeable diff since the impedance is raised from 4 to 8 ohms? How would I go about mounting this thing?

Tempe
10-10-2005, 12:00 AM
There would be an audible gap. I would not change the impedence. You really should stick with a 4 ohm tweeter.

abcheng
10-16-2005, 05:03 PM
What about CDT Audio Tweets such as their Image Enhancement sets?

Logikalliquid
10-16-2005, 08:28 PM
http://www.madisound.com/cgi-bin/index.cgi?cart_id=7372174.28173&pid=850

What about these? Isn't the tweeter the Adire Koda components tweeter was based off of?