PDA

View Full Version : Fiberglass advice....



cjj2d
09-19-2005, 10:11 AM
so I am finally going to start on my first fiverglass job. It will be to put my 5.25" midrange in the kick, and probably the tweet too.

What I was thinking, tell me if this would be a good idea or not, was find a junk yard and get a second set of kickpanels for my car and just add on to them, that way they snap right into place if that makes any sense at all.

any suggestions or advice at all is great.

Chevyaudio
09-19-2005, 10:35 AM
That is a good idea, its always better to try to find junk yard parts, that way you dont mess up your own parts.

req
09-19-2005, 10:57 AM
yes.

thats exactally what i would do and i recommend it to everyone.

mobileaudio219
09-19-2005, 11:18 AM
yes.

thats exactally what i would do and i recommend it to everyone.

^ Listen to him, as he speaks wisely.

cjj2d
09-19-2005, 11:51 AM
off to the yard....

Bake
09-19-2005, 02:41 PM
That is what I am going to do with the set I am about to start. Resin will not bond well with the plastic. I have been advised to drill small holes in the plastic so the resin will flow through them and provide a better bond.