PDA

View Full Version : Cut list help



SurgicaL
08-03-2005, 11:09 PM
Looking for a cut list for this enclosure using 1/2" MDF...not 3/4 like the drawing is for. can anyone help me out?

http://www.icixsound.com/vb/icixnation/images/2_112.jpg


Thanks

vosschs
08-03-2005, 11:50 PM
why half inch

kuijo
08-03-2005, 11:55 PM
http://www.accelerator-pedal.com/ported-box.asp

SurgicaL
08-04-2005, 12:51 AM
why half inch

becuase with 2 6.5" drivers 3/4 is not necessary especially ported.
Its also cheaper, and lighter...

Thanks for that llink kuijo....definately a favorite now :) :veryhapp:

candyman206
08-04-2005, 12:55 AM
just do the math. find out what the internsl measurements are suppose to be. Like in those dimensions, if you used 3/4'' it would be 1.5'' off of each measurement. But, if you used 1/2'' like you want to just subtract 1'' of off total dimensions just, make sure you keep the internal dimensions the same

Omarvelous
08-04-2005, 01:13 AM
just do the math. find out what the internsl measurements are suppose to be. Like in those dimensions, if you used 3/4'' it would be 1.5'' off of each measurement. But, if you used 1/2'' like you want to just subtract 1'' of off total dimensions just, make sure you keep the internal dimensions the same


As far as i can tell, being that the internal vol is what u want to maintain, must of the numbers would remain the same.

Because i'm too lazy, can't figure em out right now.

SSS 18734
08-04-2005, 01:41 AM
kuijo, u have a calculator like that, but with circular ports instead?