View Full Version : what to do with these comps

07-12-2005, 02:42 AM
ok i just got my power acoustik xp2k50c's in from etronics and i was wondering how to tweek them to get the best sound from them.........for wire terminals it has 4 that say -6db, -3db, and -0db (all for the tweeter), then for the woofer is has 1 + and 1 negative then it has one more set of + and - that say "in" what do these mean??

is this how it goes??

1. the wires from my HU (front R & L) go to the "in terminal"?
2. the woofer + & - obviously plugs into the "woofer" terminal
3. the - for the tweeter goes into the only - terminal for the tweeter obviously
4. does the "+" for the tweeter go into the terminal of my choice (-6,-3,-0)
5. are these just plug 'n play so to speak (aside from tweeking)?

which terminal should i use for the tweeter (-6,-3,-0)?

BTW i'll be pushing them with a profile 200sx (120rms, profile type-o),

any help is greatly appreciated!

07-12-2005, 02:58 AM
The amount of tweet attenuation depends on your setup, play around with all of them until you get the one you like best...

07-12-2005, 03:13 AM
ok thanks, everything else i said (#'s 1-5)were correct then?

i also have this crossover thing (freebie) if i can use it, how should i use it??
i know its a few years old (any ideas?) because fultron changed it's name to memphis, but i have no clue when, so any info is appreciated, and also could this be useful in my install, or is it useless??