PDA

View Full Version : Midbass suggestions...



Hypnoz
06-15-2005, 08:29 AM
IB in the stock door locations.

Am buying a cheap PG amp to power them. should be above 125w @ 2ohm.

Max price must be no more then $160+shipping.

Mounting depth MAX is 2.75"

What i'm looking for is SQL. I want something that will play stuff extremely accurately (for double kicks and such), yet get very loud as well to compliment a single 12" on 900w in a hatch.

I dont really care about high-end extention as they will probably be playing between 40hz-300hz or so.


Pretty specific, i was thinking perhaps the ID-chameleons... not sure how loud they can get, but ID from what ive heard has exceptional SQ.

Anyone else have some other suggestions? Thanks.

Hypnoz
06-15-2005, 09:09 AM
Just found out the cameleons are too deep. Maybe id add a 3/4" MDF ring around the stock locations so i could add some more depth....

Hypnoz
06-16-2005, 12:49 PM
No one has any suggestions?

Schuey2002
06-16-2005, 02:37 PM
If you wanted to go the DIY route, check out post #15 (by Squeak) in this thread.

http://www.caraudio.com/vb/showthread.php?t=85634&highlight=Peerless

There, it may not be much, but you now have a suggestion. ;)

Hypnoz
06-18-2005, 12:58 PM
All of those mids are 8 ohm which isnt acceptable.

Need 4 ohm...

JAZN
06-18-2005, 01:28 PM
All of those mids are 8 ohm which isnt acceptable.

Need 4 ohm...
http://www.diymobileaudio.com/forum/viewtopic.php?t=33

the chameleons can get pretty loud, and have good SQ too. like you said though, they are a b1tch to install. the mounting depth is pretty deep and the magnet is wide. i'm having to use a 1" spacer for mine and it BARELY clears the rear end, and i had to cut the door panel so it wouldnt hit it in the front.

squeak9798
06-18-2005, 01:28 PM
All of those mids are 8 ohm which isnt acceptable.

Need 4 ohm...

Do not base your decision off of the impedance of the driver. It is 100% possible that the 8ohm driver could be louder off of the same amp than a 4ohm driver. Impedance does not dictate output.

That said; check those links in that post of mine that Schuey2002 posted. Partsexpress has a ton of drivers, as does www.speakercity.com, www.zalytron.com, www.solen.ca, www.meniscusaudio.com, etc etc. Seas, Peerless, Vifa, Scanspeak, Dayton, etc etc....

3.5Max6spd
06-18-2005, 01:32 PM
Dayton has 4ohm midbass drivers