PDA

View Full Version : A little help with a sub box



D44CJ7
05-25-2005, 02:39 AM
I was woundering if some one would be able to help me design this sub box. I thought i had it figured out but ended up being way off.... I included a pic of the size of the box, this is the max size the box can be. I also drew in where ide like the Port and Sub to be. The Sub is 15" Kicker L5. I was told to tune it to 35hz. As i said i thought i had it, but when it came down to figureing the square inches of the port to convert it from square to slot, or whatever i got really lost. As i coudlnt figure how many square inches i should run? I was trying to use the WinISD software, which looks good, i guess i just dont fully under stand it, yet.

If someone could take a few mins and help me design this out it would be VERY much appreciated.

Also im sure it matters, those measurements are OD and im going to be using 3/4" MDF. I got a ID measurement of 3.479 Cubic ft. That doesnt include the displacement that the sub will take away.

Again Thank You.

-Caleb

http://redneckengineering.net/images/Boxdesign.gif

D44CJ7
05-25-2005, 06:48 PM
Bump