Just clamped my dsc 2000 after finishing my big 3. Today at work I realized I never upgraded the ground from batt to block. Major difference. Before I could pull it down to 12 now it stays at 13.
50hz sine wave ( most meters are only accurate at 50 and 60hz AC) Craftsman clamp meter
70v max output
Id say 60v before clipping
25 amps =1750 watts @ 2.8 ohms - warm coils. Amp running pretty cold after an hour of beating it.
Update tomorrow on cold coils (wired @ 1 ohm).
I dont get why my clamp tests always have so much rise on any setup. Say if I did get down to 1 ohm or even 1.5 does this mean I could get 3k out of this amp? Or does it mean if you wire to .5 and rise to 1.5 it will run really hot? Real impedance when putting out power/ subs playing is totally different than cold coils not moving I guess.