Closed Thread
Results 1 to 4 of 4

Reload Thread: need Help ASAP!!!!!!!!

  1. #1
    outa control's Avatar
    outa control is offline Junior Member



    Join Date
    Mar 2002
    Location
    Madison
    Posts
    3
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    need Help ASAP!!!!!!!!

    were is the whole to put the power wire through a car on a 88 buick lesabre







  2. #2
    Join Date
    Jan 2002
    Location
    The XXX Lounge
    Age
    34
    Posts
    4,477
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)
    You might have to drill one if you can't find a lead throught the firewall. If you have to drill a hole, be sure your only drilling through the firewall and not any electrical wires. Most newer cars have a little rubber seal, which leads past the firewall, but in a lot of older cars, you have to make your own.




  3. #3
    Nolesman's Avatar
    Nolesman is offline Member



    Join Date
    Feb 2002
    Location
    Tallahassee, FL
    Age
    34
    Posts
    75
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)
    If you cant get through the firewall, or dont want to chance it you can go throw the bottom of the car. On the front, passenger side, underneath the carpeting you might find a drain plug. YOu can go through that and wrap it up to your battery. You might want to check it though every once in a while so that your wire isnt exposed underneath the car.



    HU: Kenwood CD w/ Kenwood Chg
    FRONTS: Kenwood DB+ Excelon 2-way 6.5"
    REAR: Kenwood 3-way
    MID/HI AMP: 400x4 Fosgate Punch
    SUB: 12' Kicker VR
    SUB AMP: 250x2 Fosgate Punch
    **Soon to come... anything but those front Kenwoods, possibly Infinity Perfect Seperates

  4. #4
    SaturnScott's Avatar
    SaturnScott is offline Member



    Join Date
    Mar 2002
    Location
    Canada
    Posts
    30
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)
    It shouldn't be too hard to find the hole in the firewall.

    Lift up your hood, and trace the wires from the battery and you'll notice that they go through a hole, which usually has a rubber grommet on it, and that's where you can poke it through. It may be full, however, in which case I advise you drill a hill within close range of that hole, so your amp wires aren't causing too much interference with the motor.

    Or if you can't find it, look under the dash on the driver's side (a flashlight would come in handy here), and trace any wires backwards (towards the engine).

    Either way, it shouldn't be hard to find. And its not out of reach...



    Head Unit: Pioneer DEH-1000
    High-End: Jensen (x4) 6 1/2" w/ Tweeters
    Low-End: 1-12" Pyle BlueWave 1000 watt sub, driven by a Jensen XA2125 500 Watt amp

Closed Thread

Similar Threads

  1. Bass Blockers! Need Help ASAP
    By nofriends46 in forum Wiring, Electrical and Installation Help
    Replies: 3
    Last Post: 05-19-2002, 04:20 PM
  2. need HELP ASAP
    By outa control in forum Wiring, Electrical and Installation Help
    Replies: 1
    Last Post: 03-08-2002, 05:35 PM
  3. Dynamat, Cascade, Need Help ASAP
    By Mark_ab in forum General Discussion
    Replies: 7
    Last Post: 02-24-2002, 10:40 PM
  4. Need Help ASAP
    By Ynot in forum Wiring, Electrical and Installation Help
    Replies: 11
    Last Post: 02-04-2002, 08:59 PM
  5. Need Help Asap!
    By Unregistered in forum Subwoofers
    Replies: 2
    Last Post: 01-23-2002, 07:38 PM

User Tag List

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts
1e2 Forum